"min-pack-send-delay":"Min pack send delay (in ms)",
"min-pack-send-delay-required":"Min pack send delay is required",
"min-pack-send-delay-min":"Min pack send delay can not be less then 1",
"min-pack-send-delay-min":"Min pack send delay can not be less then 0",
"no-connectors":"No connectors",
"no-data":"No configurations",
"no-gateway-found":"No gateway found.",
@ -2725,7 +2725,7 @@
"commands":"Commands",
"send-period":"Statistic send period (in sec)",
"send-period-required":"Statistic send period is required",
"send-period-min":"Statistic send period can not be less then 1",
"send-period-min":"Statistic send period can not be less then 60",
"send-period-pattern":"Statistic send period is not valid",
"check-connectors-configuration":"Check connectors configuration (in ms)",
"check-connectors-configuration-required":"Check connectors configuration is required",
@ -2841,7 +2841,14 @@
"inactivity-timeout":"Inactivity device time after whose the gateway will disconnect device",
"inactivity-period":"Periodicity of device activity check",
"minimal-pack-delay":"Delay between sending packets (Decreasing this setting results in increased CPU usage)",
"qos":"Quality of Service in MQTT messaging (0 - at most once, 1 - at least once)"
"qos":"Quality of Service in MQTT messaging (0 - at most once, 1 - at least once)",
"server-port":"Network port on which GRPC server will listen for incoming connections.",
"grpc-keep-alive-timeout":"Maximum time (in milliseconds) the server should wait for a keepalive ping response before considering the connection dead.",
"grpc-keep-alive":"Duration (in milliseconds) between two successive keepalive ping messages when there is no active RPC call.",
"grpc-min-time-between-pings":"Minimum amount of time (in milliseconds) the server should wait between sending keepalive ping messages",
"grpc-max-pings-without-data":"Maximum number of keepalive ping messages that the server can send without receiving any data before it considers the connection dead.",
"grpc-min-ping-interval-without-data":"Minimum amount of time (in milliseconds) the server should wait between sending keepalive ping messages when there is no data being sent or received.",
"permit-without-calls":"Allow server to keep the GRPC connection alive even when there are no active RPC calls."